Replace the Electronic Display Module (EDM) for Detroit Engines
EDM C&I - Electronic Data Module
 |
| Figure 1.1 - EDM (Detroit Series 60) |
DDC P/N = 23517174
SERIAL = ED108784
STURDY P/N = 57D-02716
Detroit Diesel EDM is not clear enough to read, or not legible at all because of the prolonged exposure of the sun (refer to Figure 1.1 above). The LCD wrinkled or dark in appearance.
#Replace the EDM assembly
1). Remove the HD16-9-96S Female 9 pin Deutsch connector.
2). Remove the EDM clamps (2) and screws/bolts (6).
 |
| Figure 1.2 - EDM connector |
3). Install the new EDM assembly.
4). Install the new EDM clamps (2) and screws/bolts (6).
5). Install back the HD16-9-96S Female 9 pin Deutsch connector.
 |
| Figure 1.3 - New EDM (Detroit Series 60) |
6). Turned ON the Ignition Switch.
→This is "Plug and Play" device, and just Enjoy.
 |
| Figure 1.4 - EDM/ Ignition ON |
7). Starts the Engine.
 |
| Figure 1.5 - EDM/ Idle RPM |
 |
| Figure 1.6 - EDM/ High RPM |
0 Response to "Replace the Electronic Display Module (EDM) for Detroit Engines"
Post a Comment