Programming the New ECM using Caterpillar ET Software
WinFlash
 |
| Figure 1.1 - ECM (C13 On-Highway Truck) |
The WinFlash tool can be used to set up and consecutively program the Flash
memory of all onboard ECMs.
#Instructions:
To program an ECM:
1). Start a connection to the Service Tool. Read More: How to Connecting Caterpillar ET Software to the ECM.
→Select one of the following ECMs.... Blank Box:#2841B017JJ Flash Required.
→Select Flash.
 |
| Figure 1.2 - Blank Box:#2841B017JJ Flash Required |
2). Click the Browse button. The Flash File Selection
dialog box is displayed.
 |
| Figure 1.3 - WinFlash |
3). Select the desired file and click Open. The WinFlash screen is displayed, and
ECM/File information is populated with information from the flash file.
 |
| Figure 1.4 - Flash File Selection |
4). Click the Begin Flash button. If more than one
ECM has been selected for flashing, the Flashing Order confirmation dialog box
is displayed. This allows users to determine the order in which the
ECMs will be flashed.
 |
| Figure 1.5 - Flash In Progress |
5). The Flashing screen is displayed and the flash process will begin. This process
may be canceled at any time for one ECM by clicking the Cancel button or for all ECMs by clicking the Cancel All button.
6). When the flash process completes, a dialog displays that allows a return to the
service tool/ Cat ET, a return to WinFlash, or an Exit from the service tool. For now, Select Cat ET.
 |
| Figure 1.6 - Flash Completed Successfully! |
7). Return to the main menu, and displays the ECM Summary. In this case, there are found Active Codes (2), 22-13 and 253-2.
 |
| Figure 1.7 - ECM Summary/ Active Codes (2) |
→22-13 (Engine Speed Signal Calibration Not Performed/ 42)
Blog.Teknisi
→253-2 (Check Customer or System Parameters/ 56)
8). Select Copy Configuration from the Service menu, and then select ECM Replacement and Fleet Configuration from the sub-menu. Open ECM Replacement Files and Fleet Configuration Files (from old ECM or download from SIS), click on Program ECM. Read More: Copy Configuration Function on Caterpillar ET Software.
 |
| Figure 1.8 - Programming the ECM (ECM Replacement Files) |
0 Response to "Programming the New ECM using Caterpillar ET Software"
Post a Comment