SPN 110 - FMI 15 (Fault Code 2963)
SPN110 FMI0/15
Engine Coolant Temperature - Data Valid But Above Normal Operational Range - Least Severe Level
 |
| ISB, ISC, and ISL - Engine Coolant Temperature Sensor Circuit |
Fault Code: 2963
PID(P), SID(S): P110
SPN: 110
FMI: 0/15
Lamp: None
REASON: Engine Coolant Temperature - Data Valid But Above Normal Operational Range - Least Severe Level. Engine coolant temperature is above the engine coolant temperature engine protection
warning limit.
EFFECT: Power derate and possible engine shut down if engine protection shut down feature is
enabled.
Circuit Description:
The coolant temperature sensor is a variable resistor sensor and is used to measure the temperature of the coolant of the engine. The electronic control module (ECM) supplies 5 volts to the coolant temperature signal circuit. The ECM monitors the change in voltage caused by changes in the resistance of the sensor to determine the coolant temperature.
The engine coolant temperature value is used by the ECM for the engine protection system and for engine emissions control. This fault code indicates that the engine coolant temperature has exceeded the engine protection limit.
Component Location:
The engine coolant temperature sensor is located on the exhaust side of the engine near the thermostat housing.
Conditions for Running the Diagnostics:
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.
Conditions for Setting the Fault Codes:
The ECM detects that the coolant temperature is greater than a calibratible limit set in the ECM.
Action Taken When the Fault Code is Active:
• The ECM logs the fault code immediately when the diagnostic runs and fails.
• The torque output of the engine will be reduced.
Conditions for Clearing the Fault Code:
The ECM will turn off the fault code immediately after the coolant temperature decreases below the engine protection limit.
Shop Talk:
Verify the ECM calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM.
Read More:
Blog.Teknisi
0 Response to "SPN 110 - FMI 15 (Fault Code 2963)"
Post a Comment